It is suited for various types of connectors whether they are connected directly, fit onto a stationary connection, or are screwed on. Liquid tape will take at least four hours to dry. Two coats should be applied about 10 minutes apart. A brush is typically supplied with the product, and should be used to apply the mixture to an exposed joint. The tape requires 24 hours to completely fuse, and can be applied over soldered joints, male and female spade connectors, butt connectors, and other connections. Stretch it as you go (the tape can stretch up to three times its length) the more you do so the better the bond. Wrap the tape around the exposed conductor. Self-Fusing Silicone Tape: Hold the opposite end of the wire steady and cut off a length of tape using a razor.Let the sealant dry once you are finished. ![]() A sealant that comes in a tub can be applied with a small paintbrush. Use a 7/16 wrench to tighten the connectors and then apply the silicone sealant apply evenly if it comes in a tube and is inserted into a caulking gun. Turn off the circuit breaker and then clean the housing for the electrical wiring, using a wet rag, so the housing is clean.
0 Comments
Leave a Reply. |